wet the power cable (11) (Diag. H).
5. Clean the heating unit (water supply duct,
heating tank and resistor) (10), seated in the
middle of the tank (Diag. G) removing all
scale residue.
6. After removing any residual water, mix
about 1 litre of water and 1 litre of white wine
vinegar together and pour it into the water
tank (3); fit the lid cover (8) back on the tank
(3), wait for about 4 hours then shake the
appliance for a few minutes and repeat the
procedure indicated in Part 2. Now empty
the tank (3) and remove any scale residue
with a cloth; use plenty of drinking water
to rinse the tank (3), the unit lid (8) and
the removable water supply duct and the
heating tank (10). Leave the tank (3) and lid
(8) to drain and dry thoroughly with a soft
cloth; then replace the steam duct (10) and
the lid (8).
7. Dry the outside of the appliance by gently
wiping a dry cloth over the whole surface.
8. If the appliance will not be used for a
certain length of time, after the cleaning
procedure, carefully dry all parts immediately
and then store it away in a dry place.
9. After cleaning, replace steam duct in its
seat inside the tank by turning it counter
clockwise.
How to Clean the Appliance Outer Surface
Clean the appliance outer surface with a soft
cloth. Do not use abrasive products, alcohol,
solvents or similar products, which may
cause permanent damage to the appliance
outer surface.
Warning!!
1. Do not submerge the appliance in water
or other liquids. Do not place under running
water or allow water to enter near the
electrical parts . Should this happen, do not
use the appliance and contact your retailer
or one of The distributor Artsana S.p.A.'s
authorised service centres.
2. Keep the water well away from power
cable (11).
3. Do not scrape the heating unit (10) and do
not use chemical or abrasive products.
4. Repairs must only be carried out by a
service centre authorised by The distributor
Artsana S.p.A..
TROUBLE SHOOTING
Problem
a) The humidifier does not work
b) The appliance is very noisy.
c) Strange odour
Solution
a) Check that the power cable (11) is
connected to the mains socket.
Check that the ON/OFF switch (1) is in the
ON (I) position.
Check there is sufficient water in the tank
(3).
Send the appliance to be checked by an
The distributor Artsana service centre by
contacting the The distributor Artsana
Customer Care service.
b) Carry out the ordinary cleaning operations
as indicated in the CLEANING AND
MAINTENANCE paragraph; then air the
water tank (3) in a cool place for 24 hours
with the lid (8) open.
c) Carry out the ordinary cleaning operations
as indicated in the CLEANING AND
MAINTENANCE paragraph; then air the
water tank (3) in a cool place for 24 hours
with the lid (8) open.
TECHNICAL FEATURES
MOD. 06683
Nominal voltage: 220-240V~ 50/60Hz
Absorbed power: 270-320W
Water tank capacity: 2,3 L approx
Autonomy: 5 hours, approximately
Type of appliance: continuous operation
mode
Weight: 1,2 Kg
Measurements: 180x180x216 mm
Storage environmental conditions:
Ambient temperature: -40 ÷ +70 °C
Relative humidity: 10 ÷ 90%
53