Hilti AG 125-A36 Manual Del Usuario página 27

2.4 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not take apart, squash or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not attempt to charge or continue to use damaged batteries.
▶ If the battery is too hot to touch, it may be defective. In this case, place the power tool in a non-flammable
location, well away from flammable materials, where it can be kept under observation and left to cool
down. Contact Hilti Service after the battery has cooled down.
3 Description
3.1 Overview of the product
Guard release button
@
Spindle lockbutton
;
Air vents
=
Release button with additional function
%
(charge status display activation)
Battery
&
Switch-on interlock release button
(
On/off switch
)
Vibration-absorbing side handle
+
3.2 Intended use
The product described is a hand-held cordless angle grinder. It is designed to be used for cutting and
grinding metals and mineral materials, and for drilling tiles without use of water. It can be used only for dry
grinding / cutting.
• The tool can be used for cutting, slitting and grinding mineral materials only in combination with the
appropriate guard (optional accessory).
• It is recommended that a dust removal system consisting of matched components, i.e. dust removal
hood and a suitable Hilti vacuum cleaner, are used for working on mineral materials such as concrete or
stone. These protect the operator and increase the life of the tool and accessory tools used.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.3 Items supplied
Angle grinder, side handle, standard guard, front cover, clamping flange, clamping nut, wrench, operating
instructions.
3.4 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the power tool's performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
3.5 Guard with front cover
When grinding with straight grinding discs and cutting with cutting discs in metalworking applications,
use the standard guard with front cover.
3.6 Dust hood for cutting: DC-EX 125/5" C compact hood (accessory)
When cutting mineral materials with diamond cutting discs, use the DC-EX 125/5" C compact hood.
CAUTION Use of this hood for working on metal is prohibited.
Printed: 15.12.2016 | Doc-Nr: PUB / 5246577 / 000 / 02
1
2
Spindle
§
Standard guard
/
Clamping flange with O-ring
:
Abrasive cutting disc / abrasive grinding
∙
disc
Clamping nut
$
Kwik lock clamping nut (optional)
£
Wrench
|
3
English 21