Operation (Figure ➂); Feeding Expressed Milk; Storing Expressed Milk - NUK e-MOTION Manual Del Usuario

eMotion 1.0 0910 Cluster 1 Seite 23 Montag, 6. September 2010 6:31 18
Caution! As hygiene is of upmost importance,
please always wash your hands before expressing
milk and observe the advice in "10. Hygiene Tips"
on page 24.
Important!
= low suction
–
+ = high suction
First set the suction power regulator
minimum by rotating the ring towards the "
symbol. You can then easily increase the suction
strength as you express milk in Phase 2.
1. Switch the breast pump on. To do this, press
the On/Off button .
14
Important! The breast pump automatically
simulates your baby's natural sucking action.
2. Position the breast shield
so that the nipple is positioned in the centre
of the shield. Gently press the breast shield
in order to ensure a good seal when
expressing the milk.
Hold the pump in a
vertical position.
If you hold the pump at too great an
Note!
angle or if the pump topples over, it will
switch off automatically.
Phase 1:
the sucking rhythm is short
and stimulating to stimu-
late the natural milk flow
reflex.
Phase 2:
changes to a slow and inten-
sive suction rhythm.
Important! If the pump is switched off and
then switched on again the programme goes
back to the beginning with the fast suction
rhythm. This gives you the opportunity to
extend Phase 1.
8. Operation
3. Now you can adjust the suction using the
suction power regulator
mum suction strength is reached.
If the suction is too weak, turn dial towards
the "
If the suction is too strong, turn the suction
power dial
Note:
cally changes to a stronger suction power, so
remember to select a lower suction setting
to
17
at the beginning.
– "
Caution:
you should ensure that the expressed milk
does not reach as far as the lip valve
4. Press the On/Off button
pumping action.
5. After use, place the breast pump in the stand
6
on your breast
2
6. Unscrew the bottle
ring
bottle
7. If you are using adapter
adapter
completely from the power supply.
8. Clean the parts directly after expressing (see
"5. Cleaning and Sterilising" on page 20).
In the first minute

8.1 Feeding expressed milk

1. Screw the teat
screw ring

8.2 Storing expressed milk

After this, the pump 1. To store the milk, secure the bottle using the
supplied screw ring
Caution: Please observe the information in
section "11. Storing Milk" on page 25.
2. Using a freezer pen, write the date and time
of storage in the allocated space on the con-
tainer.
23
➂
(Figure )
17
" symbol.
+
towards the "–" symbol.
17
In phase 2 the breast pump automati-
In order not to damage the pump
14
for stability.
from the connection
5
and motor unit. Be sure to keep the
3
.
vertical
18
in order to disconnect the pump
18
onto the bottle with the
10
9 .
9 and sealing disc
until the opti-
4 .
again to stop the
disconnect the
7 .