MSA FlameGard 5 UV/IR Guia De Inicio Rapido página 2

FlameGard 5 UV/IR
Quick Start Guide
Term #
Fig. 2 Field Terminations
2. Apply Power to the Detector
Two light emitting diodes (LEDs) are visible through the UV window (the
larger window on UV/IR units). Immediately upon powering up the detector,
both LEDs will start blinking alternately for 10 seconds. The unit will then
enter the "Ready" mode. During the "Ready" mode, the green LED will flash
off 1 second, every 10 seconds.
3. Test the Detector Using the Test Lamp
Test the integrity of your system by using a FlameGard 5 Test Lamp. The
original configuration (sensitivity and relay options) can be changed by
referring to the manual and then changing the dipswitch settings located on
the bottom of the power board (SW1).
The instrument is now ready to operate. Please consult the manual for more
information on the instrument's many features.
If you have any problems in the set-up or testing of the detector, please refer
to the "Troubleshooting Section", or call the factory directly.
GB
Flame Detector
Terminal Block 2 Terminal Block 1
MAN5UVIR-QG/01
Term #