Charging Process - SEVERIN Hair Care HS 0771 Manual Del Usuario

appliances must be carried out by qualifi ed
personnel, including the replacement of the
power cord. If repairs are needed, please
send the appliance to one of our customer
service departments. The address can be
found in the appendix to this manual.
Connection to the mains supply
Make sure that the supply voltage corresponds
with the voltage marked on the rating label of
the adaptor.

Charging process

Before using the appliance for the fi rst time the
battery must be fully charged, which will take
about 12 hours. The appliance can remain on
charge for a longer period without damage or
danger, but this should generally be avoided.
With a fully charged battery, the appliance can be
operated for around 30 minutes.
If you experience a considerable decrease in
trimming performance, switch off the appliance
and recharge the battery. The appliance may
also be used with the adaptor connected
directly. In this case, however, the battery
must be briefl y charged for approximately 10
minutes. The charging process starts only once
the unit is switched off.
– Insert the connecting plug of the adaptor
into the corresponding jack on the charging
base.
– Ensure that the unit is switched off and
place it in the charging base.
– Insert the adaptor into a suitable wall
socket. The charging process begins
automatically. The red charge indicator
remains lit throughout the charging process;
it only goes out once charging is complete.
– Once the charging process is complete,
always remove the adaptor from the wall
socket fi rst before disconnecting the jack
from the charging base.
– The battery can also be recharged by
inserting the connecting plug of the adaptor
directly into the corresponding jack on
the underside of the trimmer. The red
charge indicator lights up until charging is
complete.
– While charging, the transformer within the
adaptor will become warm. This is perfectly
normal and safe and does not indicate a
malfunction of any kind.
– If the appliance has not been used for a
long period, the capacity of the battery may
decrease by a certain amount. However,
full capacity will be restored after several
charge/discharge cycles.
Use
Changing the trimming-heads
 To remove a trimming-head, fi rst turn it
anti-clockwise until the 'open-lock' symbol
on the head and the mark on the housing
are aligned; then pull the head off.
 To fi t the trimming-head, place it on the
appliance in such a way that the mark
and the 'open-lock' symbol on the head
are aligned. Then turn the head clockwise
to lock it. The mark and the 'closed-lock'
symbol are now aligned.
Fitting the push-on combs
The push-on comb attachments allow for
cutting length adjustment from 3 to 12 mm.
The medium-size comb is suitable for cutting
lengths from 3 to 6 mm, the large-size comb
for lengths from 9 to 12 mm. These comb
attachments can only be used with the wider
hair trimming-head.
When fi tting a push-on comb, ensure that it is
safely locked by the two locking buttons on the
sides. To remove the comb, push it sideways
with the thumb.
For the narrow beard/contour trimming-head,
use the smallest push-on comb.
To fi t the push-on comb, slide it over the
trimming-head from the top, ensuring that it
clicks into place. Using the locking buttons
on the sides of the trimming-head, the cutting
lengths of the comb can be adjusted to 3, 5
11