Programming Instructions - Geba Tronic Cody Universal 3 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Keypad
Programming
instructions
Please read first - then do the programming!!!
Before programming your Cody Universal 3 with your personal codes, please check the faultless
function of the appliance with the help of the factory's pass code 1234 and the
Usually, any programming is made via your personal mastercode. In order to get familiar with that kind
of programming, you start with the input of a new pass code, which replaces the one preset by the
factory (1234). The procedure is explained under item "Program 2".
After that please change the factory set mastercode to your personal code of choice.
Attention / Note
In case you made a mistake on programming, you can start over again by pushing the
button
Program 1
Input of a new mastercode
Factory setting = 1-8
Enter 8 digit
Sound signal
push
mastercode
button
Enter 8 digit
NEW
mastercode
The new mastercode is now saved!
button.
push
2x long
button
push
Sound signal
1x long
button
Transponder
Program 2
Deleting transponder keys
Delete specific keys:
Put the desired
Put DIP of the
key to the
taught-in key
to ON
The individual transponder key is now deleted!
Delete all transponder keys of an individual relay or block:
Press reset button
Put DIP of the
on the logic board
specific block or
> 5 sec
relay (1/2/3) to ON
All keys of this specific block are now deleted !
LED flashes
(2x long)
Set all DIP to
reader
OFF
Set all DIP to
OFF

Publicidad

Tabla de contenido
loading

Tabla de contenido