Water-Saving Function; Setting The Temperature Limiter; Maintenance And Cleaning; Tap Care And Cleaning - Miomare HG07028B Guía Rápida

Note: If you turn off the water flow using the control
lever then the fitting automatically switches to
6
bath filling.

Water-saving function

The cartridge in this tap has an Eco-Click
11
function. This feature limits the water flow through
the tap. This means you can save up to 50 %
water (see fig. F).
Lift the lever until you notice a slight resist-
6
ance. This resistance will cause a stop in case
of partial opening and will therefore simply
limit the flow of water.
If you want to increase the flow rate, exert slight
pressure on the lever
the resistance.

Setting the temperature limiter

The cartridge in this unit has a temperature limiter.
11
This function is not activated in the factory (neutral
setting).
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Turn off the main water supply.
Remove the plastic cover
small flat screwdriver (see Fig. C).
Release the locking screw
clockwise using a hexagon key
CAUTION! Do not take the screw completely
out; just loosen it until the control lever
be easily taken off.
Take off the control lever
Loosen the cartridge end ring
screw off the cartridge locking ring
a pipe wrench.
Now pull the setting ring
help of a screwdriver.
Note: Do not remove the cartridge.
Place the setting ring in the desired position as
shown in Fig. D.
14 GB/IE
until you overcome
6
carefully by a
8
by turning it anti-
7
.
13
can
6
.
6
by hand, then
9
by using
10
upwards with the
12
Note: The setting ring
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
tap body again by using a pipe wrench,
4
then tighten the cartridge end ring
Place the control lever
body and tighten the locking screw by turn-
4
ing it clockwise using the hexagon socket
screw key .
13
Press the plastic cover
Turn on the main water supply and check the
temperature limiter.

Maintenance and cleaning

Tap care and cleaning

Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild detergent
and a soft cloth or leather only.
Screw out the mixer nozzle
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.

Information

Potability of mains water

Find out about the potability of your mains water
supply. Your local water authority or water supply
company will be able to inform you.
can limit the turning
12
onto the
10
by hand.
9
back on to the tap
6
into the opening.
8
at regular intervals
4c