Operation - Würth 0701 138 Serie Manual Del Usuario

Drain off dirt water
ISS 55 automatic, ISS 55-S automatic on-
ly:
Illustration
 Drain off dirty water through the drainage
hose.
General
If wet dirt is vacuumed with the upholstery or
–
crevice nozzle, or if water is sucked up from a
container, it is recommended to deactivate the
"automatic filter cleaning" function.
If the maximum liquid level is reached the ap-
–
pliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids, oils,
and greases) the appliance is not
turned off when the container is full.
The filling level must be continuously
monitored and the container must be
emptied in time.
After completion of the wet vacuuming: Clean
–
the flat folded filter with the filter cleaning. Re-
move and dry the flat fold filter. Clean the elec-
trodes using a brush. Clean the container with
a damp rag and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip system. All
accessories with a nominal width of 35 mm can be
connected.

Operation

Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the main switch.
Adjust the suction output
ISS 35-S automatic, ISS 55-S automatic
only:
 Set the suction output (min - max) at the rotary
switch.
16
Working with electrical power tools
DANGER
Risk of injury and damage! The socket
outlet is only for the connection of power
tools to the vacuum cleaner. Any other
use of the socket outlet is not permitted.
 Connect the mains plug of the electric power
tool to the vacuum cleaner.
 Switch on the appliance at the main switch.
Switch on the automatic remote control:
–
 Press the bottom switch. The vacuum cleaner is
turned on and off automatically with the elec-
tric power tool.
Switch off the automatic remote control:
–
 Press the top switch.
Note: The vacuum cleaner starts automatically
within 0.5 seconds and continues to run for 15 sec-
onds after the power tool has being switched off.
Note: Please refer to "Technical specifications"
for the power connection specifications of the pow-
er tools.
Illustration
 Adjust the tool adapter to fit the connection of
the electric power tool.
Illustration
 Remove the elbow from the suction hose if nec-
essary.
 Mount hose section to the suction hose if nec-
essary.
 Mount the tool adapter to the suction hose or
hose section.
Illustration
 Connect the tool adapter to the electric power
tool.
Automatic filter cleaning
The device is equipped with a filter cleaning device
that is particularly effective with fine dust. The flat
folded filter is automatically cleaned every 15 se-
cods through an air jet (pulsating sound).
Note: Automatic filter dedusting is switched on at
the factory.
GB - 3