Bimar V360 Folleto De Instrucciones página 17

When finished, always make sure that all parts are securely coupled.
USE
Attention: the fan can only be used if it is correctly assembled in good condition.
The fan functions are operated both with the control panel keypad, and with the remote
control, which must be pointed straight-on (max distance of about 6m) towards the
control panel.
To replace the battery (type:
CR2025/3 Volts), move the tab
towards the centre "PUSH" (use a
small screwdriver) and
simultaneously remove the
battery holder. Replace the
battery (respecting the polarity)
and close the battery holder. If the remote control is not used for long periods of time,
remove the battery.
The fan has the following adjustment and control elements:
Stand-by/ON "
-
mode.
Ventilation: press the "
-
it, the speed changes. On the remote control press the "+" button to increase and the
"-" button to decrease the intensity, and the symbol corresponding to the selected
speed will light up on the display (1↔12)
Left/right oscillation, motorised and adjustable: press the "
-
each time you press it, it will change, and the symbol corresponding to the selected
oscillation will light up (L1=30°. L2=60. L3= 120°. L0= oscillation deactivated).
Motorised High / Low Tilt (100°, approx.): press the "
-
symbol appears on the display. To deactivate the function, press the key again and the
"OFF" symbol appears.
Mode: press the "
-
corresponding to the mode changes and lights up (C0= Normal; the fan can run at
constant speed (1-12).
C1=Sleep: works at the set and constant speed for
8 minutes and then switches to the lower speed (for
example: if the speed is set to 7, after 8 minutes it
will switch to speed 6, after another 8 minutes it will
switch to speed 5, and so on, until it reaches speed
1; see image on the side. If speed 1 is selected, it
will always run at constant speed.
" button to activate or deactivate the fan by placing it in stand-by
" button on the control panel repeatedly; each time you press
" button repeatedly; each time you press it, the symbol
" button repeatedly;
" key to activate it and the "UP"