Drilling Metal - Triton T12AD Instrucciones De Uso Y De Seguridad

Drilling metal

• Ensure that drill bits are suitable for the grade of metal and are within the
maximum capacity of the machine (see "Specifications")
• Mark the intended hole position using a hammer and centre punch to
ensure accuracy
WARNING: The drill bit and the workpiece will become very hot when drilling
metal. DO NOT touch the bit and never allow it to come into contact with
combustible materials when hot. Always use a suitable lubricant or cutting
fluid, and drill at appropriate speeds.
• Apply only moderate pressure to the drill bit, ensuring efficient cutting and
prolonged drill bit life
• Use a countersink bit to remove sharp burrs from the hole, preventing cuts
and other kinds of injury
• While drilling ensure swarf material does not enter the Motor Vents (1) of
the drill
Accessories
• A range of T12 accessories, including T12B 1.5Ah battery pack, T12HCB
3Ah battery pack and T12BC battery charger are available from your
Triton dealer. All Triton T12 power tools share use of the same batteries
and battery charger so by purchasing additional T12 power tools you
can supplement your number of batteries and the ability to charge more
than one battery pack simultaneously. This will increase the frequency of
charged battery packs for larger DIY projects
• Spare parts can be purchased from your Triton dealer or online at www.
toolsparesonline.com
Troubleshooting
Problem
Red LED does not illuminate and Battery (4) not
charging
Battery has low capacity
Drill cannot be switched on (Trigger (5) does
not move)
Drill does not start when Trigger is pressed
Screws do not reach deep enough into the
workpiece
Screws are driven too deep into the workpiece
surface
GB
8
810698_Z1MANPRO1-USA.indd 8
Maintenance
• This tool is manufactured using class leading components and makes
use of the latest in intelligent circuitry that protects the tool and its
components. In normal use it should provide a long working life
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal parts
to wear quickly, and shorten the machine's service life. Clean the body of
your machine with a soft brush or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes
Storage
• Store this tool and its accessories after use in its case, in a dry, secure
place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are
no longer functional and are not viable for repair.
• Do not dispose of power tools, batteries or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools and batteries
Possible cause
Battery Pack not fully seated
Battery Charger not powered
Battery pack not being fully charged
Battery pack has been charged over 100 times
and capacity has started to reduce
The Forward/Reverse Switch (2) may be in the
middle ("locked") position
Battery pack completely discharged
Defective Battery Pack
Drill defective
Required torque is beyond the capacity of the drill
Battery pack charge low
Trigger (5) held too long or at too high a speed
Solution
Refit battery pack correctly
Recheck mains connection
Wait until Green LED is illuminated
This is normal for batteries. Contact your Triton
dealer to purchase a replacement battery packs
Slide the Forward/Reverse Switch either to the
left or right
Recharge Battery pack or replace with a fully
charged Battery
Replace Battery Pack
Contact your Triton dealer or authorised service
centre
Insert fully using hand tool or pre-drill holes so
less torque is required
Recharge Battery Pack or replace with a fully
charged Battery
Practise may be required with a scrap piece of
material
26/09/2014 08:45