Hach sc200 Manual Básico Del Usuario página 19

1. In the Language screen, highlight a language in the options list and
push the ENTER key. English is the default language for the controller.
The selected language is saved. The Date Format screen appears.
2. In the Date Format screen, highlight a format and push the ENTER
key.
The date and time format is saved. Next, the Date /Time screen
appears.
3. In the Date/Time screen, push the RIGHT or LEFT arrow keys to
highlight a field, then push the UP and DOWN arrow keys to update
the value in the field. Update the other fields as necessary.
4. Push the ENTER key.
The changes are saved and the controller performs a start-up scan for
devices. If connected devices are found, the controller displays the
main measurement screen for the device in the number one position.
If the controller fails to find connected devices, refer to
Troubleshooting on page 20.
Adjust the display contrast
1. From the Settings Menu, select sc200 Setup.
2. Select Display Contrast.
3. Use the UP and DOWN arrow keys to adjust the contrast to a value
between the minimum of +1 and the maximum of +9.
Controller configuration information
General information about configuration options is listed in the table. Step-
by-step information for how to configure some of the options can be found
on the CD.
1. To navigate to the menu options, from the Settings Menu, select sc200
Setup.
Option Description
Security setup Sets the passcode preferences
Output setup Configures the controller analog outputs
Relay setup Configures the controller relays
Option Description
Display contrast Adjusts the contrast of the controller display
Set Date/Time Sets the controller time and date
Datalog setup Configures data logging options. (Available if Calculation
has been setup. At least one sensor must be attached to
enter a calculation.)
• Set Mode—Snap shot, Average, Maximum, Minimum.
• Set Interval—5 sec, 30 sec, 1 min, 2 min, 5 min, 10
min, 15 min, 30 min
Error Hold Mode Hold Outputs—Holds outputs at last known value when
controller loses communication with the sensor.
Transfer Outputs—Switches to transfer mode when
controller loses communication with the sensor. Outputs
transfer to a pre-defined value.
sc200 S/W VER:—Displays the current version of controller
Information software.
Bootloader VER:—Displays the current Bootloader
version. The Bootloader is a file that loads the main
operating system for the controller.
S/N:—Displays the controller serial number.
Edit name Assigns a name to the controller
Language Assigns the language used in the controller
2. Select an option and push ENTER to activate the menu item.
English 19