Installation - THERMEx VALENCE Instrucciones De Montaje

M 528234001218112015

INSTALLATION

Valence comes with an internal motor, and the range hood can either vent exhaust out into the
open air or re-circulate the air. If the hood is used for recirculation, a vent should not be
installed on the hood.
The hood should be installed in the ceiling.
NOTE: It is important that the structure in which the hood is installed can support its weight.
The hood is installed with the following steps:
1
Remove the upper part of the duct from
the motor frame by loosening the four
screws.
2
x4
Measure out and pre-drill the holes for
installing the hood.
NOTE: The motor frame shall be placed
correct according to the control panel.
THERMEX VALENCE 69