NORTH STATES 4913 Instrucciones página 3

Installation
Step 1
• Measure width of the opening.
• Refer to figures 1A, 1B, 1C to determine the correct installation.
28.75" – 30.75"
(73.0 – 78.1 cm)
No Extensions
Step 2
• Adding extensions, refer to figures 2A, 2B.
• Insert extension pins into hole on the outside of the gate frame. Note: the long ends of the pins go into the
gate frame, short ends go into the extension 2B.
• Slip extensions over the pins.
• Slide both the upper and lower tension bolts with rubber pads into the holes on the outside of extension.
2A
e xte ns ion
e xte ns ion pin
IMPORTANT: Do not install two extensions on the same side of the gate, as shown in gure 2C.
Step 3
• Place the gate in the opening so that the bottom of the gate frame is completely flat on the floor 3A.
• Secure the gate, fasten the mounting cups to the wall by aligning them with the bolts with rubber pads.
Use double coated tapes or screw provided 3B.
IMPORTANT: Never install this gate without mounting cups! If installing the gate at the top of stairs, use
mounting screws and cups provided.
IMPORTANT—TOP OF STAIRS NOTE: Adjust gate stopper to prevent gate door from swinging over stairs.
32.50" – 34.50"
(82.5 – 87.6 cm)
With 1 Extension
2 B
gate frame
3A
Correct!
fasten mounting cups to the wall with screws or
3B
double-coated tape.
rubbe r pa d
screw
extension pin long end
insert into the gate frame
bolt with
rubber pad
long end
tension knob
e xte ns ion
double-coated tape
36.25" – 38.25"
(92.0 – 97.1 cm)
With 2 Extensions
2C
Page 3