Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Install (2) wellnuts on hood shield flanges using (2) machine screws and (2) washers. Tighten finger
3
Expose 2" (5cm) of tape liner from each end of the flanges on the hood shield. Ensure that free ends are accessible.
4
Position hood shield in place on hood. Ensure that the well nuts in
hood shield are properly aligned with the holes in the hood.
5
With the well nut inserted into hole in hood, secure hood
shield to hood by tightening screw to expand well nut.
Repeat for remaining fastener.
7
NOTE: DO NOT OVER TIGHTEN
NOTE: Actual application may vary slightly from illustrations.
tight only at this point.
NOTE: observe the alignment from the side view in order to
guide the hood shield with its attached well nut into the proper
Hood
Hood
shield
6
Press and hold hood shield against underside lip (leading edge)
of hood while peeling backing off tape.
8
Page 2 of 3
Screw
Washer
Hood shield
Well nut
Free End
hole in the hood.
Screw and
Washer
X2
X2
Well Nut