Installation - Glacier bay 67152-6901 Guía De Uso Y Mantenimiento

Installation

1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Ensure the gasket (B) is on the bottom of the
new faucet (A).
□
Place the faucet (A) through the mounting
holes in the sink.
□
Secure the faucet (A) to the sink using the
mounting nuts (C) provided. Hand-tighten only.
NOTE: If the sink is uneven, use silicone under the
gasket (B).
C
2
□
□
A
B
4
Preparing the pop-up assembly
Remove the pop up stopper (D) and drain
ange (E) from the drain body (H).
Screw the lock nut (G) all the way down, and
push the rubber washer (F) down.
F
G
H
D
E