Homewerks 299650 Manual página 9

EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS
5.
Place the fan housing next to a ceiling joist or wall stud.
The fan housing should be level and perpendicular to
the joist or stud. Allow for thickness of ceiling board
used in your application. DO NOT flush mount to joist.
Bottom of fan housing should be flush with ceiling board.
6.
Mount the fan housing to the joist using the wood screws
(included) where indicated.
7.
Pull the wire through the hole and into the electrical box
(not included). Using wire connectors (not included),
secure 120V AC house wiring from the wall switch to the
fan as shown in the wiring diagram on the right. 14AWG is
the smallest conductor that shall be used for branch-circuit
wiring.
NOTE: Unit can be mounted in a ceiling or wall.
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house
wire represents before connecting. You may need to
consult an electrical contractor to determine safely.
Push the wires back through the hole.
8.
Install a circular 3 in. duct (not included) and secure it
with duct tape or clamps (neither included).
Finish ceiling work. The ceiling hole should be aligned
with the edge of the fan housing.
HomewerksWW.com
5
6
7
8
3 in. duct
Duct tape
or clamp
9
Ceiling