Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Remove (6) plastic seal retaining fasteners that align with the pre-
drilled holes in the hood shield. Next, carefully separate the hood
seal / gasket from the areas of the hood that align with the hood
shield flange.
NOTE: Exercise extreme caution not to tear
3
or damage the hood seal / gasket when
seperating from hood.
Insert (4) screws and washers through the rubber gasket, hood shield, and into the hood. Securely tighten.
5
Tighten all (4) fasteners until snug to secure
hood shield to hood.
6
Clean the area with an alcohol pad. Center a piece of protective film over each grease pencil mark, and wrap around the
8
NOTE: Actual application may vary slightly from illustrations.
Reposition the hood shield with the tabs sliding between the
hood and rubber seal and align with holes.
4
DO NOT OVER TIGHTEN
Note the location where the brackets will align with hood
7
hood edge.
Page 2 of 3
hood shield
hood seal / gasket
edge and mark with a grease pencil.
washer
self tapping
screw