Installation Steps - LUND Interceptor Instrucciones De Instalación

Installation Steps

Insert a small screw with small washer through hood shield and thread into bracket. Repeat for all five (5) hole
3
Position hood shield over hood edge. Note the locations where the slotted holes in brackets align with the fasteners that
secure the rubber gasket in place on the hood edge. Wrap a piece of protective film along the leading edge of the hood at
4
5
Position hood shield on hood edge, aligning the slotted holes in the bracket with the holes in the hood. Snap the bracket
in place on the hood edge by sliding it over the protective film placed in Step 4. Reposition the rubber gasket back
in place on top of the bracket. Use a large screw and large washer to secure the backet to the hood. DO NOT OVER
6
NOTE: Actual application may vary slightly from illustrations.
Carefully remove the five (5) fasteners that secure the rubber gasket in place on the hood edge.
locations. DO NOT OVER TIGHTEN!
X5
each location.
x5
Gasket
TIGHTEN!
Protective film
Bracket
Page 2 of 3
Small screw
Washer
Bracket
Hood shield
Protective film
Hood edge
Fastener
Large screw
Large washer
Rubber gasket