Replacing Carbon Brushes - Makita BFR540 Manual De Instrucciones

1
2
1
1
008262
OPERATION
Driving operation
008263
Switch on the tool by pulling the switch trigger. Hold the
tool squarely and firmly up against the driving surface. A
screw will be automatically carried to the driving position
and fastened.
CAUTION:
Always check the bit carefully for wear before
•
driving operations. Replace a worn bit or poor
fastening may result.
Always hold the tool squarely against the driving
•
surface. Holding it at an angle may damage the
screw heads and cause wear on the bit. This may
also lead to poor fastening.
Always keep the tool firmly against the driving
•
surface until the driving is over. Failure to do so
may cause insufficient fastening of screws.
Be careful not to drive a screw onto another screw
•
already fastened.
Do not operate the tool without screws. It will
•
damage the driving surface.
Do not apply oil or grease on the sliding surface of
•
the feeder box.
1. Hook
7
Driving in corner
1
15mm(5/8")
008284
This tool can be used to drive at a position 15 mm (5/8")
away from the wall as shown in the figure.
CAUTION:
Driving at a position closer than 15 mm (5/8") to the
•
wall or driving with the stopper base in contact with
the wall may damage the screw heads and cause
wear on the bit. This may also lead to poor
fastening of screws and malfunction of the tool.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.

Replacing carbon brushes

1
006258
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
1. Wall
2. Stopper base
2
1. Limit mark