Installation Steps; Care And Cleaning - LUND AVS Ventvisor Instrucciones De Instalación

Installation Steps

Slide the visor up into the window channel.
3
Position the clip so that half of the clip hangs
below the bottom of the rear end flange. En-
sure the clip is fully inserted by pressing it into
place with a putty knife.
5
NOTE: release inner window seal and repeat for
visors front end flange.

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost
pride in our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your
product is top quality in terms of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
clip installed
Repeat steps 1 thru 6 for remaining visors
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
With the visor in place, pull back the inner window
seal and press (1) clip into the window channel be-
hind the visors rear flange.
clip
4
Remove remaining tape liner by pulling on free
ends. Raise window slowly and leave up for 24
hours to secure visor to window channel.
6
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
window channel
outer window seal
inner window seal