Using The Appliance For The First Time; Aligning The Doors - tomado TSS8301B Instrucciones De Uso

USING THE APPLIANCE FOR THE FIRST TIME

Before using the appliance for the first time, you should proceed as follows: carefully unpack the appliance and remove all
packaging material and any promotional stickers. Keep the packaging (plastic bags, polystyrene and cardboard) out of the reach
of children. After unpacking the appliance, carefully check it for external damage that may have occurred during transport.
Place the appliance on a sturdy, flat surface and make sure there is enough space all around for sufficient ventilation.
A minimum space of 10 cm is required between the appliance and the surrounding walls. In this way the appliance is able
to release heat properly, cool well and function in an energy efficient way.
Do not place the appliance near heat sources such as central heating or a stove.
Do take note of the climate class of the appliance. When placed in a room that is too cold,
the refrigerator will not function properly.
• You can use the adjustable feet to the left and right to level the appliance.
• Turn the adjustable feet clockwise to raise the appliance.
• Turn the adjustable feet counter-clockwise to lower the appliance.
After placing the appliance, leave it for at least 3 hours before inserting the plug in the socket.
First clean the interior of the appliance. Use warm soapy water with, for instance, washing-up liquid, all-purpose cleaner
or soda. Wipe the inside of the appliance after cleaning with clean water and properly wipe everything dry. Leave the appliance
to dry for 1 to 2 hours.

ALIGNING THE DOORS

When the doors of the appliance have been aligned correctly in relation to the top side of the appliance, it is possible to adjust
the height. If necessary, take the following steps:
Important: the maximum height adjustment is 5 mm.
Loosen the lock nut by two clockwise turns using an open-end wrench. Now it is possible to turn the adjusting nut in order
to move the door up or down. When the door is in the correct position, tighten the lock nut again, anti-clockwise.
When the door is too low:
Open the door, use an open-end wrench to loosen
the lock nut and turn the adjusting nut anti-
clockwise to move the door upwards. When the
door is in the correct position, tighten the lock nut
again, anti-clockwise.
When the door is too high:
Open the door, use an open-end wrench to loosen
the lock nut and turn the adjusting nut clockwise
to move the door downwards. When the door
is in the correct position, tighten the lock nut again,
anti-clockwise.
L
H
fixed shaft
not even
adjustable foot
lock nut
EN - 20
adjusting nut
left
right
open-end
wrench