Publicidad
Tunnel Twister ssembly Instructions
Fig. 6
FIGURE 13
slide bracket
Fig. 6a
FIGURE 14
2" x 4" x 8-1/4"
2" x 4" x 18"
Fig. 6b
FIGURE15
exit section
2" x 4" x 7"
2" x 4" x 18"
2-1/2" screws
2" x 4" x 8-1/4"
2-1/2" screws
1-1/2" lag bolts
support bracket
9
F. SUPPORT AND BRACKET
ASSEMBLY
1. Position the slide bracket as shown in (FIG. 6).
Remove appropriate bolts from the slide (the fourth and
fifth bolts as indicated), Attach bracket to the underside
of the seam using the previously removed hardware
(FIG. 6).
2. Using holes in the bracket (indicated by arrows in
(FIG. 6)) as a guide, mark and drill 1/8" pilot holes
(1" deep). NOTE: You may need to temporarily
remove the slide bracket to drill the pilot holes.
3. Re-attach bracket (if necessary) and secure it to the
4'' x 4'' Slide Support using two 1-1/2" lag bolts .
4. Assemble the support base as shown in (FIG. 6a).
5. Attach the support bracket to the support base using
two 1-1/2" lag bolts (FIG. 6c).
NOTE: Pre-drill 1/8" pilot holes.
6. Place the support beneath the slide base and determine
its final position. NOTE: Slide support should fit tightly
beneath the slide to assure proper support. Remove
corresponding nut and bolt, attach support to the slide
as indicated in (FIG. 6b). Re-attach hardware.
7. Level grade at the bottom of the slide.
1-1/2" bolt
loc nuts
washer
Fig. 6c
FIGURE 16
Publicidad
