Installation - Glacier bay FS1A9277CP Guía De Instalación Y Cuidado

Installation

1
Installing the faucet assembly
WARNING: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet.
□
Clean off the mounting surface.
□
Remove the lock nut (F).
□
WITHOUT THE DECK PLATE: Insert the supply lines
(I) and lift rod (S) through the spout trim ring (C)
and mounting hole in the sink until the faucet (A)
sets on top of the sink, ensuring the tab on the
spout trim ring (C) is aligned with the hole at the
bottom left of the faucet (A).
□
WITH THE DECK PLATE: Align the hole in the Putty
plate (H) and deck plate (G) with the mounting
hole in the sink. Insert the supply lines (I) and
the lift rod (S) through the spout trim ring (C)
, deck plate (G) and mounting hole in the sink
until the faucet (A) sets on top of the deck plate
(G), ensuring the tab on the spout trim ring (C)
is aligned with the hole at the bottom left of the
faucet (A).
G
H
1
NOTE: If the sink is uneven, use silicone under the Putty
plate (H).
A
C
F
I
S
A
C
I
2
2
Securing the faucet
□
Slide the rubber washer (D) and metal washer
(E) over threaded rods (T) and lift rod (S). Use the
lock nuts (F) to secure the rubber washer (D) and
metal washer (E).
□
Attach the extension rod (not included) to one
lock nut (F), feed a screwdriver (not included)
through the bottom of the extension rod, and then
tighten the lock nut (F). Repeat for the second
lock nut (F).
NOTE: Make sure the faucet (A), spout trim ring (C) and
the deck plate (G) are aligned while tightening the lock
nut (F).
1
4
S
T
2
D
E
F