Ryobi CAG-180M Manual De Utilización página 14

GB
F D E
SPECIFICATIONS
Motor
No load speed
Grinding Wheel Capacity
Spindle Thread
Battery (Not Included)
Charger (Not Included)
DESCRIPTION
1. Switch trigger
2. Spindle lock
3. Lock off button
4. Rotating foot
5. Side handle
6. Wrench storage slot
7. Toolless guard
8. Disc flange
9. Grinding wheel
10. Clamp nut
11. Wrench
12. Battery pack (Not Included)
13. Spindle
14. Clasp
15. Side handle on left side of grinder
16. Side handle on right side of grinder
17. To loosen
18. To tighten
ASSEMBLY
WARNING
If any parts are damaged or missing do not
operate this product until the parts are replaced.
Failure to heed this warning could result in
serious personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
I P NL S DK
English
18 V
6,500 min-1
115 mm
M14
BPP-1815M/ BPP-1817M
BC-1800/BC-1815S
N FIN GR H CZ
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
To prevent accidental starting that could cause
serious personal injury, always remove the
battery pack from the product when assembling
parts.
ATTACHING THE SIDE HANDLE (Fig. 2)
Remove the battery pack from the grinder.
■
Screw the handle into the side of the gear housing.
■
NOTE: You can install the handle on the top, left, or right
side of the grinder, depending on operator preference.
The handle must always be used to prevent loss of
control and possible serious injury.
Tighten the side handle securely.
■
OPERATION
WARNING
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating products.
Failure to do so could result in objects being
thrown into your eyes, resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the purposes listed below:
Grinding metals
■
Sanding wood or metal surfaces
■
Cutting metals with thin disc (approximately 1 mm)
■
TO INSTALL BATTERY PACK (NOT INCLUDED) (Fig. 3)
Place the battery pack on the tool.
■
Make sure the latches on each side of the battery
■
pack snap into place and the battery pack is secured
on the tool before beginning operation.
10
RUS RO PL SLO HR TR