Continuous Operation - swissflex uni 75RF Modo De Empleo

Continuous operation

Figure 1:
Function button with
LED on the control system
5
7
4
Operating instructions
Swissflex
uni _75RF, _85RF, _95RF
1.
transmitter to the mains. (Wait at least 10 sec.
before initial setup).
2.
system twice (figure 1). The function button and
the under-floor lighting light up, and the system
is now in learning mode for about 10 seconds.
3.
held transmitter at the same time and hold them
down. The function LED (6) begins to flash. Hold
the button down until the blue LED is permanent-
ly illuminated (activation time about 10 sec.).
4.
ter fails or the handheld transmitter is turned off,
you can interrupt the communication between the
handheld transmitter and the control system as
6
follows:
Press the function button of the control system
8
four times in quick succession (figure 1).
• The function button on the control system
• The function button on the control system goes
5.
Figure 2
slat bases:
®
Connect the control system and the handheld
Briefly press the function button of the control
Press buttons (7) + (8) (figure 2) of the hand-
If the programming of the handheld transmit-
lights up, now press the function button on the
control system once.
off, and the handheld transmitter is deactiva-
ted.
Continuous on/off with button (5) (figure 2).
GB