Tripp-Lite B160-101-DPSI El Manual Del Propietario página 23

Troubleshooting
7. Check cabling for any damages that may have occurred during
installation. If a cable connector is loosened from pulling through
ceilings/wall or the cable jacket is damaged with the wiring exposed,
maximum performance will not be achieved.
8. Are the transmitter(s) and/or receiver(s) located in an area with
exposure to higher temperatures? If the product is overheated, it will
not function properly.
9. Do not set identical channel numbers for transmitters in an
Unmanaged Switch installation. Doing so will result in no signal being
displayed on monitors connected to receivers assigned to the same
channel number. If this happens, change the transmitters' channel
numbers to unique numbers and assign the desired channel number to
the affected receivers. If audio/video does not reappear after doing this,
disconnect power from the affected transmitter and receiver units, wait
10 seconds, and reconnect the power.
10. Do not connect more than two transmitters in an unmanaged
switch installation. Unmanaged switch installations are limited to two
transmitters, with the number of receivers being limited to the number
of ports remaining on the unmanaged switch.
11. Do not connect other networking equipment to the network
switch. The B160-Series Audio/Video over IP Extenders are designed
for use with a dedicated network switch. Connecting them to a switch
used with other networking equipment will result in degraded or non-
functional product performance.
23