Fanimation PICKETT FP7996 Serie Manual De Instrucciones página 7

How to Assemble Your Ceiling Fan
6. Reinstall the hanger ball on the downrod as follows.
Route the black, white, blue wires and
through the hanger ball. Position the pin through the
two holes in the downrod and align the hanger ball
so the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against the
pin. Securely tighten the set screw in the hanger
ball. A loose set screw could create fan wobble.
(Figure 6)
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the top of the downrod. Strip insulation off
1/2 inch from the end of each lead wire. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
safety cable
7
(continued)
Figure 6
Figure 7