Care And Maintenance - Uline H-5221 Manual Del Usuario

knob, press the igniter button several times until the
pilot flame comes on. After lighting the pilot, wait 15
seconds to heat the thermocouple, before releasing
the control knob. Release the variable control knob
after the pilot flame lights.
4. If the pilot does not light, repeat steps 2 to 3.
NOTE: If a new tank has just been connected,
please allow at least one minute for the air in
the gas pipeline to purge out through the pilot
hole.
WARNING! FOR YOUR SAFETY:
• Do NOT touch or move heater for at least 45
minutes after use.
• Reflector is hot to the touch.
• Allow reflector to cool before touching.
• Keep exterior surfaces clean.
• Use warm, soapy water for cleaning. Never use
flammable or corrosive cleaning agents.
• While cleaning your unit, be sure to keep the area
around the burner and pilot assembly dry at all
times. Do not submerge the control valve assembly.
If the gas control is submerged in water, do NOT use
it. It must be replaced.
• Keep the appliance area clear and free from
combustible materials, gasoline and other
flammable vapors and liquids.
• Do not obstruct the flow of combustion and
ventilation air.
• Keep the ventilation opening(s) of the cylinder
enclosure free and clear from debris.
• Air flow must be unobstructed. Keep controls, burner
and circulating air passageways clean.
• Spiders and insects can nest in burner or orifices.
This dangerous condition can damage heater and
render it unsafe for use. Clean burner holes by using
a heavy-duty pipe cleaner. Compressed air may
help clear away smaller particles.
• Carbon deposits may create a fire hazard. Clean
dome and burner screen with warm, soapy water if
any carbon deposits develop.
NOTE: In a salt-air environment (such as near
an ocean), corrosion occurs more quickly than
normal. Frequently check for corroded areas
and repair them promptly.
PAGE 7 OF 27
OPERATION CONTINUED
5. After the flame comes on, leave the variable control
TURNING THE HEATER AND PILOT LIGHT OFF
1. Turn control knob to "PILOT."
2. Press down lightly and turn to "OFF."
3. Turn the gas tank off completely.
4. Wait five minutes before relighting.

CARE AND MAINTENANCE

• Use high-quality automobile wax to help maintain
BETWEEN USES:
• Turn control knob off.
• Disconnect LP source.
• Store heater upright in an area sheltered from direct
• If desired, cover heater to protect exterior surfaces
DURING PERIODS OF EXTENDED INACTIVITY OR
WHEN TRANSPORTING:
• Turn control knob off.
• Disconnect LP source and move to a secure, well-
• Store heater upright in an area sheltered from direct
• If desired, cover heater to protect exterior surfaces
• Never leave LP cylinder exposed to direct sunlight or
SERVICE:
Only a qualified service person should repair gas
passages and associated components.
knob on LO for about five minutes, and then switch
to the desired temperature.
the appearance of the heater. Apply to exterior
surfaces from the pole down. Do not apply to
emitter screen or domes.
contact with inclement weather (such as rain, sleet,
hail, snow, dust and debris).
and to help prevent buildup in air passages.
NOTE: Wait until heater is cool before covering.
ventilated location outdoors.
contact with inclement weather (such as rain, sleet,
hail, snow, dust and debris).
and to help prevent buildup in air passages.
excessive heat.
NOTE: Wait until heater is cool before covering.
CAUTION! Always allow heater to cool before
attempting service.
1220 IH-5221