Echo 99944200240 Manual De Instrucciones página 2

2
NYLON LINE REPLACEMENT
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Press tab (A) in housing and twist cover CCW (counter clockwise) to align
arrows (B) and remove cover and button. Lift spool from housing. Assure
spring stays in housing.
3. Use one piece of new nylon line 6m (20 ft.) long and thread through the
molded loop (C) on the spool. Pull line tight and adjust so one end is 15cm
(6 in.) longer than the other.
4. Hold spool with words "THIS SIDE UP" facing you. Place index finger
between the strands and wind line tightly and evenly in the direction of
arrow on spool (clockwise).
5. Place ends of line in the two notches (D) molded in the spool with 12.5 to
15.2 cm (5 to 6 in.) protruding.
6. Thread line end through housing eyelets (E). Install spool into housing over
spring (F) and be sure spool is installed so that the words "THIS SIDE
UP" are visible.
7. Place button and cover on spool and align arrows (B). Push down on cover
and twist cover clockwise until tab locks cover in place.
8. Before using, test head. Push center button while pulling on line. Trimmer
line should advance approximately 1 (one) inch.
NYLON LINE HEAD INSTRUCTIONS
A
C
D
E
E
F
B
B
D