Tips And Tricks - Würth 0714 58 229 Traducción Del Manual De Instrucciones De Servicio Original

J Continue as described until the adhesive beam is
completely cut through. Cut off the cutting wire 2
at the spool. Undo the cutting thread at the
attachment hook so that it can be reused. Then
release the screen removal device from the
windscreen and remove from the vehicle.

Tips and tricks

• Before cutting out, inspect the new windscreen to
determine where possible clips and spacers could
be placed.
• With very old or very cold adhesive bead, the
cutting process can be very difficult. Heating with
a hot air blower, but not above 100°C, simplifies
the work.
• The wire probe 6 can be heated with the hot air
blower. This simplifies puncturing of the adhesive
bead. Nevertheless plastic parts should be pro-
tected against damage.
• Screens with vulcanised seals can be removed
without damage and reused. To do this the wire
or braid must be placed below the seal.
Removal of rear windscreens
• Attach the wire end with the attachment hook to a
suitable point. If necessary protect critical areas
with adhesive tape.
Removal of side windows
• Side windows can be removed provided there is
sufficient space for the suction device and opera-
tion of the ratchet mechanism.
BDA_Scheibenaustrenn-Set_Basic.indd 11
11
11.09.14 17:34