Operating the awning
➤ Slide the struts together completely.
➤ Fold the right strut up.
➤ Turn the right strut into the lead rail.
➤ Slide the bottom part of the right strut into the latch of the lead rail.
➤ Retract the other strut in the same way.
7.6
Adjusting the motor (optional)
I
NOTE
The 12 V motor is pre-assembled in the roller tube.
➤ If the awning no longer fully closes or opens, then adjust the 12 V motor (fig. e,
page 8).
7.7
Replacing the batteries of the remote control and the
wall switch (accessory) (optional)
I
NOTE
If the LED of the remote control does not light up after pressing one of
the buttons, the remote control battery is flat.
➤ Open the housing (fig. f 1, page 8).
➤ Remove the old battery from the holder.
➤ Insert a new battery (type CR2450 for remote control, type CR2430 for wall
switch, fig. f 2, page 8) into the holder with the positive terminal facing
upwards.
➤ Reassemble the remote control or wall switch.
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of them at
collection points.
18
PW3800
EN