Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Connect the water supply line (not included) between the tank (B)
B
and shut-o valve. Tighten the tank connection coupling nut ¼ turn
beyond hand tight. DO NOT OVERTIGHTEN THE TANK CONNECTION.
2.
Turn on the supply valve and allow the tank (A) to fill.
3.
Check for leakage at all connections and tighten or correct as needed.
1.
Install the quick removal metal hinge with expansion bolt (M)
onto the toilet bowl (A) through the seat holes.
2.
Place the metal hinge cover (N) over top, aligning the hole with
N
the screw, and tighten from the top with a screwdriver.
M
A
1.
Place the seat cover (D) onto the bowl (B) and align the quick removal
slot with the metal hinge (M) that is installed on the bowl (A).
2.
Hold the seat cover (D) vertically and push the seat slot into the hinge
(M) to secure.
NOTE
Loosen the hinge screws (M) and adjust the metal hinge pin location
if the seat does not align with the bowl completely.
1.
To remove the seat cover (D) from the bowl (A), grasp the seat cover
vertically and lift o the hinge pin (M).
PAGE 6
2-Piece High Efficiency Toilet
Installation Instructions
Publicidad
Tabla de contenido
