ADA INSTRUMENTS CUBE 3D Manual Del Usuario página 4

4
English
CHANGE OF BATTERIES
Open battery compartment. Insert batteries. Take care to correct polarity.
Close battery compartment. ATTENTION: If you are not going to use instru-
ment for a long time, take out batteries.
OPERATION
Cube 3D is a reliable and convenient line laser. It will be irreplaceable line
laser for many years. Place the line laser on the working surface or mount
it on the tripod/pillar or wall mount. Switch on the line laser. Visual alarm
(blinking line) and audible signal indicate that the device was not installed
within the compensation range ± 3º. To properly work align the unit in a hor-
izontal plane. Turn the compensator switch (3) to the position "ON" (the line
laser is turned off in the position OFF). At that compensator of the line laser
will be in free position (it will be blocked in the position OFF). When switching
on, one horizontal and one vertical lines will be projected. Press button (6)
to turn on additional vertical line. Press button (6) again to have only one
additional vertical line. Press button (6) one more time to turn off additional
vertical line and switch on horizontal line.
Use the receiver (supplied separately) mode to enlarge the working mode
and for the operation in bright illumination. Press and hold button (6) for
more than 2 sec to switch on the receiver mode. The mode is activated after
the sound alarm. Press and hold button (6) for more than 2 sec again to
switch off the receiver mode.
3
TO CHECK THE ACCURACY OF LINE LASER (SLOPE OF PLANE)
Set up the line laser between two walls, the distance is 5m.Turn on the line
laser and mark the point of cross laser line on the wall. Set up the line laser
0,5-0,7m away from the wall and make, as described above, the same mas-
rks. If the difference {a1-b2} and {b1-b2} is less then the value of