LUND 318099 Instrucciones De Instalación página 3

Installation Steps
Select (1) 8mm Bolt Plate, and (1) Plastic Retainer. Partially thread the Retainer onto the Bolt Plate. Insert the Bolt Plate into
the Driver side front outer mounting location. Select (1) 8mm Offset Bolt Plate, and (1) Plastic Retainer. Partially thread the
Retainer onto the Offset Bolt Plate. Insert the Offset Bolt Plate into the Driver side front inner mounting location. Thread the
Retainers until tight against floor panel. Hang Driver side front bracket from bolts with (2) 8mm Flange Nuts. Do not tighten
3
Select (1) 8mm Bolt Plate, and (1) Plastic Retainer. Partially thread the Retainer onto the Bolt Plate. Insert the Bolt Plate into
the Driver side rear outer mounting location. Select (1) 8mm Offset Bolt Plate, and (1) Plastic Retainer. Partially thread the
Retainer onto the Offset Bolt Plate. Insert the Offset Bolt Plate into the Driver side rear inner mounting location. Thread the
Retainers until tight against floor panel. Hang driver side rear Bracket from bolts with (2) 8mm Flange Nuts. Do not tighten
4
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
hardware at this time. (Fig. 5 & 6)
hardware at this time. (Fig. 7 & 8)
Page 3 of 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8