Publicidad
Idiomas disponibles
Idiomas disponibles
Rear View
1
ON
MAIN
OFF
~
AC IN
7
1. MAIN switch
This is the main power switch. When using this unit,
set this switch to ON. Otherwise, the power cannot
be turned on/off using the POWER button on the front
of the unit.
2. CAMERA OUT connectors
Camera video output connectors for use of BNC con-
nectors. If the MAIN switch is ON, the loop through
output is possible for the camera image inputted into
each CAMERA IN connector.
3. CAMERA IN connectors
Input connector for signal of camera (BNC connector).
4. GND terminals
It is the common GND terminal.
5. AUDIO connectors
AUDIO IN connector
Input connector for audio signal (RCA pin).
AUDIO OUT connector
Output connector for audio signal (RCA pin).
6. MIC jack
Input connector for microphone (600 ohm imped-
ance). Use of MIC for audio recording has priority to
use of the AUDIO IN connector.
7. AC power socket
This socket connects to the power cord. Earth ter-
minal is for safety. Use the 100 ~ 240V plug with
earth for the power of this unit.
This unit must be earthed at all times. Never con-
nect this unit to a power outlet which does not have an
earth terminal.
Please use the AC power cord accessory.
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• QUICK GUIDE
2 3
IN
1
2
3
4
5
OUT
OUTPUT A OUTPUT B
VIDEO
Y/C
REMOTE
RESET
RS-485/
RS-422
8
9
10
11
4
CAMERA
6
7
8
9
10
11
GND
ALARM IN
RS-232C
12
13
14
8. VIDEO OUT connectors
OUTPUT A VIDEO connector
Output connector for video signal to monitor (BNC
connector).
OUTPUT A S(Y/C) connector
This is output connector for video signals that sepa-
rate brightness signals and color signals for higher
picture quality. Simultaneous output along with OUT-
PUT A VIDEO is also possible.
OUTPUT B connector
Output connector for video signal to monitor only for
live image (BNC connector).
9. RS-485/RS-422 connectors
Connectors for operations of pan, tilt and zoom when
these connectors are connected to dome camera.
10. REMOTE jack
Input connector for wired remote control.
11. RESET button
Pressing this button resets the unit and the power
turns off. In this case, video data, menu settings and
the current time are kept.
12. ALARM IN terminals
Input terminal for alarm signal.
13. I/O terminals
CLOCK ADJ terminal
Input terminal to set the present time. Time display
is adjusted to the nearest hour (00 minutes 00 sec-
onds) when this terminal receives the CLOCK ADJ
signal.
INFORMATION
The on-screen clock can be reset to the nearest hour,
by applying a signal to the CLOCK ADJ terminal. For
example, if the current time is 11:29:59, it will be reset
to 11:00:00, and if the current time is 11:30:00, it will be
reset to 12:00:00.
6
5
IN
12
13
14
15
16
OUT
AUDIO
MIC
OUT
IN
ETHERNET
SCSI
RECEIVE
SEND
15
16
5
Publicidad
