Connections To Be Made; For Models With A Factory Amplifier - Metra Electronics Axxess BX-CH34 Instrucciones De Instalación

Attention!
This interface will work with models that are either factory
amplified, or non-amplified. Please follow the instructions carefully for your
model vehicle. Failure to do so will result in either no sound, or low sound.
If you are unsure if your vehicle is factory amplified or not, please contact
your local dealership.

For models with a factory amplifier:

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the (2) Red wires to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire. (This wire must be
connected to hear sound from the factory amplifier.)
• Connect the Orange/White wire to the illumination wire. (If the aftermarket
radio has no illumination wire, tape off and disregard this wire.)
• Tape off and disregard the Brown wire, it will not be used in this application.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
BX-CH34

Connections to be made

The following (3) wires are for multimedia/navigation radios that require these wires.
3
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Connect the Green/Purple wire to the reverse wire (if applicable).
• Connect the Light Green wire to the parking brake wire (if applicable).
• Connect the Blue/Pink wire to the VSS/speed sense wire (if applicable).
From the LD-BX-CH3 or LD-BX-CH4 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue or Blue/White wire to the antenna turn-on wire (if populated
on the factory harness). (The LD-BX-CH4 uses a Blue wire; the LD-BX-CH3
uses a Blue/White wire)
• Disregard the 4-pin connector with White, White/Black, Gray, and Gray/Black
wires, it will not be used in this application.
• Disregard the 4-pin harness with stripped leads, it will not be used in this application.
• Leave the connected (2) 4-pin connectors that have Green, Green/Black,
Purple, and Purple/Black wires.
Continue to 3.5mm jack steering wheel control retention