Shroud Removal; Battery Removal - Sunrise Medical Zippie ZM-310 Manual De Instrucciones

Z I PP IE Z M- 310
E. SHROUD REMOVAL
The plastic protective shroud can be removed for adjustment or servicing.
1. Remove the top shroud
a. Remove the Seat (Section Q previous page).
b. Remove the six screws(A) that hold the shroud to the frame.
c. Once all of the screws have been removed, the shroud should be free to remove.
2. Remove the rear shroud
a. Remove the two rear shroud screws.
b. Pull downward at the top of the rear shroud, then lift up and off.
3. Replacing the front, or rear shroud
a. Position the shroud and hand thread a few screws to hold the shroud in place.
b. You can then insert the other screws while moving the shroud to line up the holes.
c. Be sure not to tighten screws too much, because it could fracture the plastic.
F. BATTERY REMOVAL
1. To remove the batteries before transporting or servicing:
a. Carefully flip back the seat (see Section O Seat removal)
b. Remove the shroud .
c. Unplug the main power connect (B)
d. Lift the batteries out of the frame using the battery strap as a lifting handle.
2. Battery installation
• See section X. (Batteries) for installation
Batteries may weigh up to 39 lbs. Care must be taken to avoid injury when lifting up on bat-
tery straps.
47
48
49
WARNING
XI. DEALER SERVICE & ADJUSTMENT
29
A
B
47
48
49
127899 Rev. A