Seat Height Adjustment; Seat To Floor Height/Pre-Tilt Positioning; Battery Wiring Diagram - Sunrise Medical Zippie ZM-310 Manual De Instrucciones

Z I PP IE Z M- 310 Z I PP IE Z M- 310
P. SEAT HEIGHT ADJUSTMENT
a. After removing the seat, remove the lockout Pin (A) from all 4 seat mount posts.
b. In most cases, select the desired seat height by moving all four post up the same dis-
tance, so the seating system is level following the adjustment.
c. Reinsert the hardware
Q. SEAT TO FLOOR HEIGHT/PRE-TILT POSITIONING
Your ASAP II seating system can be adjusted to many different seat to floor heights, and pre-
tilt positioning depending on your specific configuration. Seat to floor heights and Pre-tilt
positioning should only be altered by a trained medical professional. For the correct Pre-tilt
settings and seat to floor heights, in relation to specific configurations of the Zm-310, please
Refer to the seat to floor matrix in the Zm-310 service manual before changing any of the
factory settings.
DO NOT increase the front post height independent from the rear posts when providing
seating pre-tilt.
NOTE– For chairs configured with SPOT tilt, do not increase the Pre-tilt greater than 3 degrees.
For chairs configured with seat elevator, do not increase the Pre-tilt greater than 3 degrees.
For chairs configured with SPOT tilt and seat elevator, do not increase the seat-to-floor
height greater than 1" fron the lowest position.
For chairs configured with SPOT tilt and recline, do not increase the seat to floor height
greater than 18", and do not increase the pre-tilt greater than 0 degrees.
R. BATTERY WIRING DIAGRAM
127899 Rev. A
66
67
WARNING
69
34
XI. DEALER SERVICE & ADJUSTMENT
A
68
Front Seat post
Hole 1
Hole 2
Hole 3
Hole 4
Hole 5
Rear Seat post
Hole A
Hole B
Hole C
Hole D
Hole E
ZM-310 Wiring diagram
67
68
69