Adam Adax WT Guia Del Usuario página 7

Thermostat Userguide Adax WT
Thermostat layout
1. Display - shows the desired temperature
2. Red light - Lights when the heater is warming
3. Blue light - Wi-Fi indicator - lights up when the
heater is installed and connected
4. "ok" for activating different functions (see
explanation in the manual)
5. Increases the desired temperature
6. Decrease the desired temperature
Switch the heater on / off with the button
on the right side of the heater.
This Adax WiFi thermostat is intended for remote control via the Adax WiFi App.
The product can also be used without App connection as follow (manual use):
Main features for manual use
1. Set the desired temperature with the 5 (+) or 6 (-) buttons on the thermostat.
2. Key lock / child lock. The thermostat can be protected from unwanted use that children and others
cannot change settings. This function is turned on / off by holding the 4 (ok) button for 5 seconds until
CC flashes in the display, repeat the process to turn key lock off.
3. Turn display light on / off. This function is turned on / off by holding the 6 (-) and 4 (ok) buttons for
5 seconds until display flashes 3 times. The display will turn off 30 seconds after adjustment and will be
lit again by pressing any button (+, - or ok).
4. To enable programs (schedule program, anti frost, etc.), the heaters must be installed and controlled
via the Adax WiFi app.
Control the heater with Adax WiFi App on your mobile.
Important: When installing heaters, your phone must be connected to your routers 2.4GHz band.
A detailed user manual step by step with pictures can be found at www.adax.no/wi-fi
1. Download "Adax WiFi" for Apple in App Store or for Android in Google Play.
2. Follow the instructions in the App for installation.
3. When the heater is installed, all the heater functions are controlled via the App.
4. From the App, heaters can be connected to zones (rooms), set desired heating and decreasing
periods with weekly programs.
Tips and additional features.
1. Reset to factory settings - Hold "+", "-" and "ok" until the display quickly flashes with "rE" and then goes
to 20 degrees.
2. In case of power outage, the heater will start to heat at the last recorded temperature when power is back.
3. When the heater is connected to the app, child protection is activated via the App and not manually on the
thermostat.
4. Turn on / off display light. This function is turned on / off by holding the 6 (-) and 4 (ok) buttons for 5
seconds. The light (s) will turn off after 30 seconds and will be lit again by pressing any button (+, - or ok).
EN
2019-01-14 art.no.: 62008
Wi-Fi 2,4 GHz, WPA2, 802.11 b/g
iPhone (IOS 10.0 or higher)
Android 5.0 or higher
7