Light Bulb Replacement - Jacuzzi Whirlpool Bath DESIGNER Serie Manual De Instalación Y Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Suction Cover/Strainer Maintenance
Clean the suction cover/strainer of hair and debris when neces-
sary. To do this, remove the center screw and detach the square
cover. Clean the cover by backflushing debris from the holes. Re-
place the suction cover immediately after cleaning. When reinstall-
ing, orient the cover/strainer with the small notch at the bottom. The
gasket must be inserted into the groove of the cover/strainer before
reinstalling onto the suction fitting.
CAUTION: Keep hair a minimum of 6 inches away from the suc-
tion fitting at all times when the whirlpool system is operating.
Hair longer than shoulder length should be secured close to the
head, or a bathing cap should be worn. Do not operate the whirl-
pool system with the suction cover removed! It is a safety de-
vice and must always be in place on the suction fitting to mini-
mize the potential hazard of hair and body entrapment.
SUCTION COVER/STRAINER ASSEMBLY
COVER STRAINER
SCREW
NOTCH
Spinning Jets Maintenance
(Models equipped with spinning jets)
If hair or other kind of debris gets caught in the bearings of these jets,
it could cause them to stop spinning. This may require disassembly
and cleaning. To do this, simply grab the nozzle and pull straight out
of the jet housing. The bearing casing will be attached to the nozzle.
These can be separated by holding the casing and pushing the nozzle
out from the rear of the casing. After cleaning, reassemble in reverse.
PUSH FROM REAR
TO REMOVE
NOZZLE
BEARING CASING
Lamp
Some baths come equipped with an underwater lamp. An op-
tional lamp kit is available from your Jacuzzi Whirlpool Bath dealer for
installation on your bath.
When the bulb burns out, replace it from the back of the lamp
fitting, on the underside of the shell, by pulling out the bulb recep-
tacle. Replacement bulbs (12V 7W) are available from your Jacuzzi
Whirlpool Bath dealer.

LIGHT BULB REPLACEMENT

SUCTION
FITTING
GASKET
NOZZLE
18
LOCKING NUT
LIGHT BULB
BULB RECEPTACLE
LENS
LIGHT BEZEL
SHELL

Publicidad

Tabla de contenido
loading

Productos relacionados para Jacuzzi Whirlpool Bath DESIGNER Serie

Tabla de contenido