Dimmer Curves; Device Information - Cameo TS 100 WW Manual De Usuario

Settings
Display = Display lighting
DMX Fail = Operating status with
DMX signal fault
DimCurve = dimmer curve
DimResp. = Dimmer response
PWM = LED PWM frequency

Dimmer curves

linear
DMX value

DEVICE INFORMATION

Press MENU to access the selection menu for system settings. Using the UP and DOWN controls, select the menu item "Sys info" and confirm
with ENTER. This will take you to the sub-menu for displaying device information. Use the UP and DOWN buttons to select the desired submenu
item and then press ENTER to retrieve the information (see table). Press MENU repeatedly to return to the main display. The main display is
activated automatically if no input is made within approximately 30 seconds.
Sys Info
Temp = Displays temperature of
LED unit
Op.Hours = Operating time display
Firmware = Displays device software
version
8
Backlight ON
Backlight Off
Hold
Blackout
Linear
Exp
Log
S-Curve
LED
Halogen
650Hz
1530Hz
3600Hz
25000Hz
exponential logarithmic
DMX value
DMX value
Temp LED
Temp °C/°F
Hour xxxh
Soft Ver
On permanently
Deactivates after approximately 30 seconds of inactivity
Last DMX command will be retained
Activates blackout
Light intensity increases linearly with DMX value
Light intensity can be finely adjusted at lower DMX values and broadly
adjusted at higher DMX values.
Light intensity can be broadly adjusted at lower DMX values and finely
adjusted at higher DMX values.
Light intensity can be finely adjusted at lower and higher DMX values
and broadly adjusted at medium DMX values.
Lamp responds abruptly to changes in DMX value
Lamp behaves like a halogen spotlight with soft brightness changes
Configuration of LED PWM frequency
S-curve
DMX value
xxC / xxF
°C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
Displays total operating time in hours
V1.xx