Safety Instructions - Urrea 2493 Manual De Usuario

IMPORTANT
• Read these safety instructions and
the instructions for installation and
operation and maintenance, and keep
them carefully for later need.
• This Shop Crane is designed to be used
as an elevator in the industry and
mechanical workshops for handling
of the motors. Any other application
beyond established terms for use will
considered inappropriate.
• Try properly, and be sure that every
piece and component are in good
conditions before of use.
• Take special care with accessories of
elevation used such as slings, brackets,
balancers, etc.. Its use should only
authorized personnel,
carefully and understand the contents
of this manual.
• DO NOT modify the characteristics of
the Shop Crane.
• Failure to follow these rules may result
in damage to the user, the shop Crane
or the piece to raise.
• The manufacturer will not accept any
responsibility for the incorrect use of
the Shop Crane.

SAFETY INSTRUCTIONS

• The load be lifted should never
exceed the capacity of
the Shop Crane (A), in
all his positions (read
the maximum capacity
load in this manual).
• Secure element lifted
against all types of
sliding. DO NOT apply lateral pressure
at load lifted.
• The Shop Crane should lean on firm
surface, regular,
of unnecessary elements and well
illuminated. DO NOT lean never the
Shop Crane in a surface that can sink.
• The capacity of the Shop Crane will
after read
horizontal, free
decreases as
extends in all its
positions.
• Secure that there
is no people below
or close of the Shop
Crane during use.
• Before working
with the Shop Crane make sure that
the slide is completely firm on the
screw cap (B). The Shop Crane must be
in the closest position of the load de
lifted.
• There must not be any periphery
objects that difficult lifting load or
obstacles which avoid its descent.
• While securing the load to the hook
always use suitable lifting accessories
and a higher load capacity to raise.
• Be sure that the
safety trigger hook
is working properly.
• To raise
load stable and
balanced, suspend
the hook and note
that its center of
gravity should
always be within
the brackets of the
shop Crane.
• DO NOT allow
balancing or violent
descent as it could
be dangerous (C).
• DO NOT place any part of the body
under high load (D) nor climb on the
Shop Crane.
• The Shop Crane is not a transport
element nor is it a device to maintain
the high load for an unlimited time.
MAINTENANCE
• .
Both maintenance (E) of the Shop
Crane as repair should be performed
only by those qualified by training and
experience, knowledge of the hydraulic
E N G L I S H
it
the
7