Publicidad
Idiomas disponibles
Idiomas disponibles
Abnormity and countermeasure in use
index
abnormities
1
After finishing the nor-
mal shredding, it runs
ceaselessly yet.
2
Paper feed or positive
rotation is normal, but
there are still some
scrapped paper han-
ging at the exit after
finishing.
3
It can't work if feeding
paper follows withdra-
wing paper.
4
Some paper is in the
entry, but shredder
does not work.
5
The paper is jammed,
and the machine stops
rotating.
6
The machine doesn't
start after inserting a
sheet of paper, or stop
running when paper is
being inserted.
14
Cause
Too much scrapped pa-
per in the wastebasket,
so that the just scrap-
ped paper cannot fall
and leave in the entry.
The slots of the blades
clamp the scrapped
paper.
Some scrapped paper
lock automatic inducti-
ve device.
After feeding paper,
any corner of the paper
is inserted, but the rest
doesn't touch automa-
tic inductive device.
1. The number of the
inserted paper is larger
than the limitation
2. Locked rotor makes
the motor overheated
and then temperature
protection set takes
action.
The paper is too thin,
too soft, humid, or too
crinkly to activate auto-
matic inductive device.
Countermeasure
1. Cut off the power,
and empty the wasteba-
sket.
2. Cut off the power,
and press the scrapped
paper down to make
them away from the
machine head.
Set the slide switch to
"REV" (if need, please
clean the scrapped pa-
per at the exit).
Set the slide switch to
"REV".
Adapt to the position of
the feeding paper and
make it touch the auto-
matic inductive device.
1. Set the slide switch
to "REV" and withdraw
the shredding paper.
2. Unplug the plug and
let the machine stop for
a while.
1. Fold the paper and
then insert it.
2. Set the slide switch
to "REV".
Publicidad
