5
Insert the camera.
Center the camera in the camera guides with
the lens positioned in the lens window.
D
The Camera Strap
To ensure that the camera strap does not get caught in the seal and cause a leak, be sure
to remove the strap before placing the camera in the case.
D
Underwater Flash Units (0 17)
En
The underwater fl ash unit will only fi re when the camera's
built-in fl ash is raised; after placing the camera in the case,
raise the built-in fl ash, but note that the fl ash will fi re with
every shot taken. Be sure to lower the built-in fl ash when
using the case without an underwater fl ash unit.
6
Insert desiccant.
To prevent condensation from forming inside
the case, insert the supplied silica gel desic-
cant between the bottom of the camera and
the case. Slide the desiccant to the front,
where it will not interfere with the case clos-
ing. Improper placement could cause the case
to leak.
A
Replacing the Desiccant
Used desiccant loses its capacity to absorb moisture. We recommend replacing the desic-
cant each time the case is used (0 17).
7
Camera guides
Flash pop-up control