Transport And Installation En; Current Clamp En - Abicor Binzel FES-200 W3 Instrucciones De Servicio

FES-200 W3
Fume extraction system FES-200 W3
1
Torch system
2
Putting into operation
Fig. 7
1 Connect the torch system (2), hose and rubber connector to the fume extraction system.
NOTICE
• When fixing the current clamp (4), make sure that the red point points to the torch system.
2 Connect the current clamp (4) to the fume extraction system (1) and fasten it on the extraction hose (3)
(cable assembly) of the torch system(2). (Option)
3 Connect the dedusting system to the compressed air.
4 Plug in mains plug.
6.1 Transport and installation
Select a location that allows a short and straight extraction hose feed and prevents it from entering the
employee's space of movement.
6.2 Current clamp
The current clamp allows you to switch on automatically the FES-200 when the welding process starts.
1
Manometer
1
Fig. 8 Complete current clamp
4
3
Extraction hose (cable assembly)
3
2
Rotary switch (I-0-Auto)
2
1
2
4
Complete current clamp, 4 pole (deviating figure possible)
3
6 Putting into operation
Current clamp, 4 pole (deviating
figure possible)
3
EN - 15