Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Defect, failure
Motor does not run
Motor does not run in automatic
mode
Reduced suction power
No suction power in case of wet
vacuuming
Voltage fluctuation
Storage
Packed appliance may be stored in dry, unheated storage place with tempera-
ture not lower than –5°C.
Unpacked appliance should be stored only in dry storage place with tempera-
ture not lower than +5°C with exclusion of all sudden temperature changes.
Environmental protection
Power tools, accessories and packaging should be sorted for environmental-
friendly recycling.
Only for EU countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC on waste electrical and elec-
tronic equipment and its incorporation into national law, power tools that are
no longer suitable for must be separately collected and sent for recovery in an
environmental-friendly manner.
Warranty
Our equipment is under warranty for at least 12 months with regard to ma-
terial or production faults in accordance with national legislation. In the EU
countries, the warranty period for exclusively private use is 24 months (an
invoice or delivery note is required as proof of purchase).
Damage resulting from, in particular, normal wear and tear, overloading, im-
proper handling, or caused by the user or other damage caused by not fol-
lowing the operating instructions, or any fault acknowledged at the time of
purchase, is not covered by the warranty.
Complaints will only be acknowledged if the equipment has not been disman-
tled before being sent back to the suppliers or to an authorised NAREX cus-
tomer support workshop. Store the operating instructions, safety notes, spare
parts list and proof of purchase in a safe place. In addition, the manufacturer's
current warranty conditions apply.
Cause
> Socket fuse falling-out
> Activated overload protection
> Defective motor
> El. tool is defective or is not connected correctly
> Too low power input of the el. tool
> Too low suction power is set on the suction power
controller
> Clogged suction hose/nozzle
> The vacuum cleaner canister, dust or filter bag is full
> Filter cartridge is soiled
> Sealing between the canister and the top vacuum
cleaner part is defective or missing
> Self-cleaning mechanism is defective
> Vacuum cleaner canister is full
> Too high power supply impedance
Remedy
• Activate the fuse
• Switch the vacuum cleaner off, let it cool for 5 minutes. If
the cleaner still cannot be started, call the Narex company
service station
• Ask the Narex company service station for motor replace-
ment
• Check function of el. tool and/or push the plug into the
socket firmly
• Observe the minimum power input P>40 W
• Set the suction force, see par. "Suction force control"
• Clean the suction hose/nozzle
• See par: "Vacuum cleaner canister emptying" or "Dust bag
replacement", "Filter bag replacement"
• See par. "Filter cartridge cleaning" or "Filter cartridge
replacement"
• Replace and/or insert sealing
• Inform the Narex company service station
• Switch the appliance off. Empty the vacuum cleaner
canister
• Connect the appliance with another socket, closer to the
terminal box. If impedance in the transfer point is ≤ 0.15 Ω,
there is no need to assume that the voltage will fluctuate
by more than 7%
Noise Information
Measured values determined according to EN 60 704-1.
Noise:
Sound pressure level:
L
Sound power level:
L
In accuracy of measurements K = 3dB (A).
Certificate of Conformity
We declare hereby that this device meets requirements of the following stand-
ards and directives.
Safety:
EN 60335-1; EN 60335-2-69
Directive 2006/95/EC
Electromagnetic compatibility:
EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3
Directive 2004/108/EC
2009
Narex s.r.o.
Chelčického 1932
470 01 Česká Lípa
Changes are reserved
English
= 62 dB(A)
pA
= 59 dB(A)
wA
Antonín Pomeisl
CEO of the company
29. 12. 2009
15
Publicidad
Tabla de contenido
