Publicidad
Idiomas disponibles
Idiomas disponibles
ROBO Compact W600
NOTICE
• Note the following instructions:
3 Product description on page EN-6
• Select the correct wire type and appropriate wire guide for your application.
• Use insulated liners or PA liners only.
• New and unused spiral liners or PA liners must be shortened to the actual length of the
cable assembly. Please observe the product information in relation to the cut-to-length
wire guide (liner or PA liner).
• Spiral liners = for steel and stainless steels
• PA liners = for aluminium, copper, nickel and stainless steels
The ROBO welding torch is delivered with standard wear parts. For information about replacing
wear parts, refer to the following chapter:
9.3 Replacing wear parts on page EN-20
6.1 Setting up and connecting torch neck and cable assembly
Carry out each step in accordance with the figures below:
Fig. 2
Setting up and connecting torch neck and cable assembly
1 Lay down the cable assembly straight.
2 Remove wear parts.
3 Shorten the wire guide (liner or PA liner) according to the product information. Insert into the
cable assembly and secure depending on the version.
6.1.1 Euro-ZA on page EN-12
6.1.2 RPC on page EN-12
4 Reassemble wear parts. Tighten the contact tip using a switch key wrench and screw the gas
nozzle onto the torch head.
BAL.0374.0 • 2019-04-01
B
6 Putting into operation
A
EN - 11
Publicidad
