Power Supply; Attaching The Grinding Wheel; Use; Switching On And Off - Metabo W 14-125 Ergo Manual Original

parting work is performed (see chapter 11 Acces-
sories).
See illustration E on page 3.
- Push and hold the lever (12). Place the safety
guard (9) in the position indicated.
- Release the lever and turn the safety guard until
the lever engages.
- Push the lever and turn the safety guard until the
closed section is facing the operator.
- Make sure that the guard is seated securely: the
lever must engage and you should not be able to
turn the safety guard.
6.3 Rotatable main handle
Only work with the main handle (7) engaged.
See illustration B on page 3.
- Push in the button (6).
- The main handle (7) can now be turned 90° to
both sides and can be engaged.
- Make sure that it is securely positioned: the main
handle (7) must be engaged and it should not be
possible to move it.
6.4

Power supply

The mains sockets must be protected using time-
delay fuses or circuit breakers.
7 Attaching the grinding
wheel
Disconnect the mains plug before changing
any accessories. The machine must be
switched off and the spindle at a standstill.
For reasons of safety, attach the parting
guard before performing parting work (see
chapter 11 Accessories).
7.1 Locking the spindle
Press in the spindle locking button (3) only
when the spindle is stationary!
- Press in the spindle locking button (3) and turn
the spindle
(2) by hand until you feel the spindle locking
button engage.
7.2 Placing the grinding wheel in position
See illustration C on page 3.
- Fit the support flange (1) on the spindle. The
flange should not turn on the spindle when prop-
erly attached.
- Position the grinding wheel on the support flange
(1) as shown in illustration C.
The grinding wheel must lay flat on the
supporting flange. The metal flange on the
parting grinder disc must lay flat on the support
flange.
7.3 Securing/Releasing the clamping nut
Securing the clamping nut (10):
The 2 sides of the clamping nut are different.
Screw the clamping nut onto the spindle as
follows:
See illustration D on page 3.
- A) For thin grinding wheels:
The edge of the clamping nut (10) faces upwards
so that the thin grinding wheel can be attached
securely.
B) For thick grinding wheels:
The edge of the clamping nut (10) faces down-
wards so that the clamping nut can be attached
securely to the spindle.
- Lock the spindle. Turn the clamping nut (10)
clockwise using the 2-hole spanner (11) to
secure.
Releasing the clamping nut:
- Lock the spindle (see chapter 7.1). Turn the
clamping nut (10) anticlockwise using the 2-hole
spanner (11) to unscrew.

8 Use

8.1

Switching On and Off

Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When
switching the machine on and off, keep it away
from dust deposits. After switching off the
machine, only place it down when the motor has
come to a standstill.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from the
mains socket or if there has been a power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands at the intended handles, take a secure
stance and concentrate on the work.
See illustration A on page 3.
ENGLISH
ENG
17