NuTone 8490-220 Instrucciones De Instalación página 2

MAKING THE CONNECTIONS
1. Remove one of the two side knockouts from the outlet box.
7
Install ⁄ " box connector (not supplied). Insert house wiring
8
approximately six inches through box connector and tighten
screws to secure. Using wire nuts (not supplied) connect house
wiring to receptacle in outlet box cover: black to black and white
to white. Secure ground (bare wire) under green ground screw in
outlet box.
2. Install outlet box in opening of housing and secure with two short
screws provided. Feed all wiring into outlet box and secure cover.
INSTALLATION
IN NEW CONSTRUCTION
MOUNTING THE HOUSING
1. Remove grille screw and motor bracket assembly from unit.
NOTE: These pieces can be set aside until the finished ceiling
is in place.
2. Insert outlet box into housing and secure with two short
screws (supplied).
3. Remove appropriate knockout from outlet box and install
a box connector.
4. Insert mounting brackets into slots in fan housing.
5. Remove tape from louvers and be certain both damper
sections operate freely.
6. Place hanger bars into mounting brackets. Nail hanger bars
to joist, adjusting slightly so housing will be held firmly in place.
Raise or lower mounting brackets to adjust housing so plaster
flange will fit flush to finished ceiling.
7. Connect 8" ductwork.
MAKING THE CONNECTIONS
IMPORTANT: Be certain all wiring complies with electrical codes
and the unit is properly grounded. Disconnect power at circuit
breaker.
1. Run house wiring (with ground) THROUGH BOX CONNECTOR.
Using wire nuts (not supplied) connect house wiring to fan: black
to black, white to white. Connect ground wire to green ground
screw.
2. Secure junction box cover.
COMPLETING THE INSTALLATION
1. Mount Motor/Blade assembly into housing with plug towards
receptacle. Hook keyhole slots in motor mounting bracket over
two (2) mounting screws. Tighten screws and plug motor into
receptacle. Be certain fan blade spins freely.
2. Place grille over unit and secure with supplied thumbscrew.
3. Re-connect power and check for proper operation.
NOTE: An optional washable, permanent filter may be used
with this fan. If desired, order NuTone Model 854 separately.
MAINTENANCE
Grille should be cleaned with a mild soap and water solution.
•
If the optional filter is used, it may be removed and cleaned in
•
sudsy water. Rinse thoroughly and allow to dry completely before
placing into Ceiling Fan. For best results, clean filter frequently.
Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in U.S.A., Rev. 5/01, Part No. 88200