Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Remove hood shield from hood. Use a small pry bar to remove the factory installed fasteners attaching the rubber seal to the
Location marked in Step 2
3
Remove and discard the factory installed fastener.
Fastener
4
Insert (6) receptacles UNDER rubber trim and through hood shield, and then into hood.
6
Gently pull the rubber seal back, and install (1) screw through hood shield flange and into
7
NOTE: Actual application may vary slightly from illustrations.
hood at the (6) locations marked in Step 2.
rubber trim
hood. Repeat for remaining locations.
X6
Reposition the hood shield on the hood with the flanges sliding
between the hood and the rubber seal. Align holes in hood shield
5
hood shield
receptacle
X6
Page 2 of 3
NOTE: Exercise extreme caution not to tear
or damage the rubber seal when seperating
from hood.
flange with holes in hood.
hood shield
receptacle
screw
rubber trim